JFK Assassination Forum
JFK Assassination Discussion & Debate => JFK Assassination Discussion & Debate => Topic started by: Charles Collins on October 31, 2019, 10:34:45 AM
-
On page 243 of “JFK Assassination Logic” John McAdams writes:
“When pathology professor and assassination researcher John Nichols tested a Mannlicher-Carcano identical to Oswald’s, he found that the bullet penetrated forty-seven inches of laminated, knot-free pine.”
The source note 119: J.M. Nichols, “Assassination of President Kennedy,” The Practitioner 211(1973): 625-33.
While searching for confirmation, I watched a (2013) documentary film for Nova titled “Cold Case JFK.” In it a test is shown where the bullet penetrates 47 pieces of pine. These are 3/4” thick pieces (which are commonly called 1 by whatever the nominal width is). The actual penetration was therefore 36 inches (not 47”). I have a problem believing that there is actually 11” difference in the two tests. And thought that a likely explanation might be the confusion in the nomenclature of calling a 3/4” thick board a 1 by.
Does anyone here have access to the 1973 test report by Nichols? My searches have come up empty so far. Thanks.
-
On page 243 of “JFK Assassination Logic” John McAdams writes:
“When pathology professor and assassination researcher John Nichols tested a Mannlicher-Carcano identical to Oswald’s, he found that the bullet penetrated forty-seven inches of laminated, knot-free pine.”
The source note 119: J.M. Nichols, “Assassination of President Kennedy,” The Practitioner 211(1973): 625-33.
While searching for confirmation, I watched a (2013) documentary film for Nova titled “Cold Case JFK.” In it a test is shown where the bullet penetrates 47 pieces of pine. These are 3/4” thick pieces (which are commonly called 1 by whatever the nominal width is). The actual penetration was therefore 36 inches (not 47”). I have a problem believing that there is actually 11” difference in the two tests. And thought that a likely explanation might be the confusion in the nomenclature of calling a 3/4” thick board a 1 by.
Does anyone here have access to the 1973 test report by Nichols? My searches have come up empty so far. Thanks.
Charles: I believe you want this?
http://jfk.hood.edu/Collection/Weisberg%20Subject%20Index%20Files/N%20Disk/Nichols%20John/Item%2016.pdf
It's a crude copy and is hard to read.
-
Charles: I believe you want this?
http://jfk.hood.edu/Collection/Weisberg%20Subject%20Index%20Files/N%20Disk/Nichols%20John/Item%2016.pdf
It's a crude copy and is hard to read.
Thanks Steve, that looks like what I am looking for! Thumb1:
-
Charles: I believe you want this?
http://jfk.hood.edu/Collection/Weisberg%20Subject%20Index%20Files/N%20Disk/Nichols%20John/Item%2016.pdf
It's a crude copy and is hard to read.
Thanks again Steve, unless I missed something, it appears that Nichols only did some mathematical calculations concerning the penetrating power and didn't actually fire a bullet into the laminated pine. This would explain the real world test results (by Haag in the Nova program) difference of about 11-inches.